IEC 60684-3-213:1998 pdf download.Flexible insulating sleeving – Part 3: Specification for individual types of sleeving – Sheet 21 3: Heat-shrinkable polyolefin sleeving, not flame retarded
1 Scope
This sheet of IEC 60684-3 gives the requirements for one type of heat-shrinkable polyolefin sleeving with a temperature index of 1 35 and a nominal shrink ratio of 2:1 . The sleeving is not flame retarded. This sleeving is normally supplied with internal diameter up to 1 02 mm and is transparent. Sizes other than those specifically listed in this standard may be available as custom items. These items shall be considered to comply with this standard if they comply with the property requirements listed in tables 1 , 2, 3, 4 and 5.
2 Normative references
The following normative documents contain provisions which, through reference in this text, constitute provisions of this sheet of IEC 60684-3. For dated references, subsequent amendments to, or revisions of, any of these publications do not apply. However, parties to agreements based on this sheet of IEC 60684-3 are encouraged to investigate the possibility of applying the most recent editions of the normative documents indicated below. For undated references, the latest edition of the normative document referred to applies. Members of IEC and ISO maintain registers of currently valid International Standards.
IEC 60684-1 :1 980, Specification for flexible insulating sleeving – Part 1 : Definitions and
general requirements
IEC 60684-2:1 984, Specification for flexible insulation sleeving – Part 2: Methods of test
ISO 846:1 978, Plastics – Determination of behaviour under the action of fungi and bacteria –
Evaluation by visual examination or measurement of change in mass or physical properties
ISO 1 81 7,— Rubber, vulcanized – Determination of the effect of liquids
Any abbreviation used for colour shall comply with IEC 60757 where applicable. Non-standard
colours shall be written out in full.
* TT designates transparent sleeving.
4 Conditions of test
Unless otherwise specified, the sleeving shall be shrunk in a forced air circulation oven for
(5 ± 1 ) min at 200 °C ± 5 K prior to testing.
5 Requirements
In addition to the general requirements given in IEC 60684-1 , the sleeving shall comply with
the requirements of tables 1 , 2, 3, 4 and 5.
6 Product qualification
Product qualification shall normally be based on the results from size 1 2,7/6,4 mm.
IEC 60684-3-213:1998 pdf download
